China
||  Your current location:Home page - NEWS - Company News
What should be paid attention to when spraying diatom mud with THT spraying machine?
Release time:2019.03.13    Sources of news:Qingdao THT Electromechanical technology co. LTD   Times of browsing:

Now a lot of places are directly decorated with diatom mud, diatom mud is a new kind of environmental protection decoration coating.

There are many advantages to decorating with diatom mud:

1, environmental protection no odor, no formaldehyde

2, can be fire retardant

3, can also reduce noise absorption

4. Soft colors

If manual construction, a day is only 300 square meters, using THT spray machine, such as BM87s, BM84s, TK3 model construction, a day can be more than 2000 square meters.

Some customers asked, if the wall is not flat so how to construction?

This and spray with putty is the same truth, need artificial first leveling the following, then no gas spray coating machine spraying, the effect will be very good, and not delay money, conservative estimates, a day can also income of more than 1000 yuan.


The construction steps are briefly described as follows:

Trim walls, fill in potholes, or remove protruding impurities.

2. Mix the diatom mud and water in a ratio of about 1 to 1. Use a high-speed mixer to mix well.

The proportion of water can also be changed according to the actual situation. Thicker diatom mud can be sprayed with the spraying machine of tu huite.

3, open the tu huite spray machine, open the machine for spraying, the nozzle can choose 537 539 model.

4, spraying from the wall about 30 cm to 50 cm is the best, too close to the wall may be pitted, because the pressure of the machine is very large.

5. When holding the spray gun, the moving speed should be even, not high or low, slow or fast, so as to ensure better effect of diatom mud on the wall.

6, if it is a fine decoration of the house, can be manually scraped flat, if you need to do the modeling, you can do the modeling after the end of the spray half dry state.

7, after the end of spraying must be cleaned spraying machine, to prevent the diatom mud dry, blocked by the gun, blocking the high-pressure pipe, thus affecting the use of spraying machine.

Spraying diatom ooze tools there are a lot of, in addition to high-pressure airless spraying machine, such as hydraulic piston pump sprayer with hunter, is there anything else can spray air spray gun, with small electric watering can, or a small air pump spray gun, but this kind of spray out efficiency is slow, a day, hundreds of square, repair can also, but if construction, artificial how much faster than, spraying area is smaller.

Another need to pay attention to is the diatom mud inside if there are impurities, on the spray machine will also have an impact, may block the gun, and putty spray gun is the same reason.

So, want to filter with filter net below, better, purify impurity, gush out the effect is better.



【Next】THT Sprayer will meet you in Shanghai International Hardware Fair 1th Apirl  [2019.03.21]
【Last】THT putty sprayer manufacturers hold national agent conference  [2019.03.11]
 
WeChat QR code
Scanning WeChat
Contact US About US Cooperative unit
TEL:4000518532 18561638852 出口部Export Department 86-13165056621
FAX:0532-83650866
ADDRESS:Jiaozhou Taiwan industrial park, Qingdao, shandong
E-MAIL:tuhuitekeji@163.com Skype: 18561638852@163.com
About US
Culture
Industry news
Problem
Copyright 2006 - 2024  Qingdao THT Electromechanical technology co. LTD(www.tht168.com)  All Right Reserved.      You are the fifth 730410 visitor!